Verint Nextiva S1700e Series Podręcznik Użytkownika Pobierz pdf (Strona 25)

Nextiva S1700e Series User Guide

Verint Video Solutions 13

12. In the Units tab, click Discover.

The new S1700e device appears.

13. Select the device, then click Configure.

14. Configure the serial port parameters to match those of the

target equipment (for instance, camera or PTZ keyboard).

For more information, refer to the SConfigurator User

Guide.

cThe S1700e initial configuration is now complete. You perform

further configuration with the web interface (see page 27),

SConfigurator, or a video management software from Verint

Video Solutions.

Using the Encoders

The incoming stream of a video input is sent to two separate

encoders. You can have the following scenarios with regards to

the encoder use:

Note: You cannot use the web interface and a video

management software at the same time.

Performing a Point-to-Point

Connection

To view video on a monitor in a point-to-point context (as

opposed to using a video management software), you have to

create a fixed connection between an S1700e transmitter and

an S1500e receiver. Typically, both devices sit on the same IP

subnet as SConfigurator and have the same VSIP port; to

access other devices, refer to the device discovery section in

the SConfigurator User Guide.

Note: The receiver must be running firmware version 3.10 or

higher.

Scenario Encoder 1 Encoder 2

point-to-point point-to-point unused

video management software view at rate A record at rate B

web interface web viewing point-to-point

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 94 95

Brak uwag

Verint Nextiva S1700e Series Podręcznik Użytkownika Strona 25