Verint Nextiva S1700e Series Podręcznik Użytkownika Pobierz pdf (Strona 22)

2: Configuring and Installing the Device

10 Verint Video Solutions

6. Power the S1700e transmitter by plugging the power cord

between the injector and the outlet.

Preparing a 12V DC Device

To prepare a 12V DC device for configuration:

1. In a lab, unpack the S1700e and place it on a table.

2. Establish the Ethernet connection by plugging a cable

(crossover or straight-through) into the LAN 10/100

connector on the front of the device.

The crossover cable is to directly connect the device to a

computer; the straight-through cable is to integrate the

S1700e on a network.

Warning: Never plug a PoE injector into the LAN 10/100

connector on an S1700e-12VDC device.

Otherwise, the device will be damaged and the

warranty becomes void.

3. Power the device. If you are using the supplied power

supply:

a. Plug the power supply wire with the dashed white lines

in the GND pole on the back of the device.

b. Plug the other power wire in the +12V pole on the back

of the device.

c. Connect the electric plug into the outlet.

For any other power supply, refer to the manufacturer

documentation for the proper wiring scheme.

Setting Device Parameters

The first step in installing an S1700e device is to change its IP

address to ensure compatibility with an existing network. The

default IP addresses of all devices are based on the APIPA

addressing scheme and will be in the range 169.254.X.Y, where

X and Y are relative to the MAC address of the individual

device; for more information about APIPA, see page 53.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 94 95

Brak uwag

Verint Nextiva S1700e Series Podręcznik Użytkownika Strona 22